Skip to content

Count-Up Timers

A count-up timer counts elapsed time upward from zero — a “days since last incident” board, a shift timer, or anything you time by hand rather than counting down to a fixed date.

  1. Go to Content > Hub and click Time under Add new content.
  2. Choose Count-Up Timer and click Next.
  3. Enter a Name, set the options below, and click Next.
  4. On Add to page, pick a page and area to put it on, or click Next to skip.
  5. Click Create.

The timer starts at zero and does nothing until you press Start.

SettingDescriptionDefault
Display FormatDate (days elapsed only) or Date & Time (full elapsed breakdown)Date & Time
Unit LabelCustom label for the elapsed unit in Date mode, e.g. “Days”, “Shifts”Days
Show SecondsShow seconds ticking (Date & Time mode only)Off
Timer HeaderOptional text above the timer, e.g. “Days Since Last Incident”—

Unlike a clock or countdown, a count-up timer only moves when you tell it to. Two places show its controls as small icon buttons:

  • On its card in the Content Hub’s Hub tab, under Your content library.
  • On the selected area in the Page editor — select the area and the controls appear in a small bar at the bottom of it.
ButtonEffect
StartBegins counting up from the current elapsed time (zero, the first time)
StopFreezes the timer at its current elapsed value
ResetAsks you to confirm, then sets the elapsed time back to zero

Only the buttons that apply are shown: Start while stopped, Stop while running.

The timer isn’t moving. It only counts while running. Open its card in the Hub or select its area on the Page and press Start.

I reset it by mistake. Reset can’t be undone. Press Start again to begin a new count from zero.